This rail truck was inspired by RGS#1 , made to fit inside an Ford Ranger by
taking off the front foot board. Made from 6061 aluminum as much as possible.
6 dia“ front, 7 dia” back wheels, all RMI steel wheels 75” long, 25 ½” wide,
29” tall, weight ~275#, 24 volt. has a horn relay installed for you choice of
horn. Battery powered by 2 wheel chair motors (1/3 HPea) with an Diverse
Electronics controller with regenerative brakes, 2 -12volt 35AH batteries
inside the “tank” , room for larger batteries if desired, The rail truck is
setup to be a ride behind operation. Coupler height, front 6 ¼”, rear 7”
Chain drive geared for 6 MPH top speed , cooling fan for the controller, set
to run at 75’ $4,250 FOB Yakima, WA
This is a one of a kind, well built & detailed.
SOLD
“Gilpin Tram” Ore Car
3 ¾” scale 7½" gauge
SOLD
“Gilpin Tram” ore car, 68”long, 18”wide, 16” high. Weight 154#
Mercer 2 ½” scale couplers, coupler height is 7” Roll Models D&RG trucks with
5 ½”spiral backs (Griffin) Hand brake handle is a dummy. Brake line has been
installed on the car for future brake installation. The car can be used as a
ballast car , the bottom doors open, the car is painted with Krylon red oxide
primer paint $2,000 FOB Yakima, WA
This is a one of a kind, well built & detailed.
SOLD
